|
Tractor Talk Discussion Board |
Re: Pulling capability 2 wd vs. 4 wd
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by barnrat on February 21, 2006 at 15:29:22 from (12.39.89.199):
In Reply to: Re: Pulling capability 2 wd vs. 4 wd posted by Mark on February 21, 2006 at 14:09:38:
I'll give you a real world example. My manure spreader says that you need 70 pto hp to run it. In the winter time or mud season I run a 2wd 95 hp Massey 1100 that weighs about 11,000lbs and at times I can barely pull it through the mud or snow. A neighbor runs the exact same spreader with a 75hp 820 Belarus 4wd that weighs about 9000lbs. I've seen him drag the spreader on the frame through the mud and still keep going.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|