|
Tractor Talk Discussion Board |
Re: Pulling capability 2 wd vs. 4 wd
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IaGary on February 21, 2006 at 15:24:26 from (216.51.139.145):
In Reply to: Re: Pulling capability 2 wd vs. 4 wd posted by Mark on February 21, 2006 at 14:09:38:
No the smaller 4 wd will pull it but maybe not as fast because of lower horsepower but it will pull it. I had 165 hp 2wd and a 165 hp 4wd both 1086 IH.In ideal conditions the 4 wd would pull same 24 ft disc in same gear but less wheel slip so you where moving about .5 mph faster.In less than perfect conditions the 4 wd was much better. Had a 90 hp 4wd 10,000lb loader tractor that will push more than 150 hp 2 wheel 13,000lb with loader. But on lighter pushing jobs the 150 will push it faster. Hope this all makes it a little clearer.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|