|
Tractor Talk Discussion Board |
Re: Truck to Tractor conversion
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Truth seeker on February 18, 2006 at 19:41:21 from (170.215.133.106):
In Reply to: Truck to Tractor conversion posted by Truth seeker on February 18, 2006 at 17:53:10:
Brrr!
I know, it isn't anything like nebraska, but 12 degrees is cold enough for me!
I like the idea about using blocks between the springs and frame, although I'll probably end up replacing the springs.
How many GPM would a hydraulic motor require? I'm kinda toying with the idea that it could power a baler, but it doesn't NEED to.
Would weight in the back solve the pulling problem? I'll have to remove the bed anyhow.
Thanks once again!
P.S. I think that the farm show magazine should be supported; its been a great inspiration for me!
How many people have a subscription?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
