Tractor Talk Discussion Board |
Re: ih 1456 remote hydraulics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ron 1456 on February 14, 2006 at 15:09:29 from (12.108.222.9):
In Reply to: ih 1456 remote hydraulics posted by Ryan Hansen on February 14, 2006 at 13:06:29:
In addition to the 2 previously mentioned ways you can also add a power beyond end cap to the second valve if your tractor has a second valve with an end cap. Some tractors used a second valve without an end cap. If yours has this type of second valve you would have to replace it with a valve like the first one. In theory it is posible to stack the valves and use as many valves as you want but you run into problems with operating the valves and doing the plumbing away from them. If you can get access to a parts book it will help you a lot.
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|