Tractor Talk Discussion Board |
Re: How Would You Do It? Question from the Dummy
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DRL on February 07, 2006 at 16:03:58 from (24.32.122.56):
In Reply to: How Would You Do It? Question from the Dummy posted by Allan in NE on February 07, 2006 at 15:24:21:
On the trailer question: How long is the wheel base of the truck? I would think that one with a "regular" length wheel base would fit on the trailer, but if it has a long wheel base or the box/bed extends way over the rear wheels, you may come up short. If the truck will fit on the trailer, I would say that's the way to go. Last week I was in the same spot you are in now. I had purchased an old implement truck that was about 200 miles away. Drove my little truck up there and loaded it on the big truck. The drive home was uneventful, but every little noise, smell, etc. got the pucker factor on high alert. My little truck was about like a flea on a dog as far as weight goes, and after 200 miles of bouncing and bumping I was glad to be home. Gave me a renewed respect for those who drove a truck for a living before air ride cabs, seats, etc. The most important piece of equipment you could bring along with you is your cell phone. That way you could call and get help if there is trouble. Good luck. Your are coming close to getting a full operation going!
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|