Re: mazda b4000 head torq

Posted by Jon Holt on February 05, 2006 at 19:36:54 from (207.200.116.14):

In Reply to: mazda b4000 head torq posted by chris sweetland on February 05, 2006 at 08:15:33:

Mazda has a service bulletin for the torque. I don't know how to copy it and paste it on here. I will write it down. If you looked down at the head, start with the second bolt in from the upper left, then the third from the lower left, third from the upper left, second from the lower left, first from the upper left, first from the lower left, the far upper right bolt and last, the far lower right bolt. The torque specs are as follows. There is a note about installing the intake manifold and torquing the head and intake bolts alternately to ensur proper fit and gasket crush. First torque is 52 ft-lbs. Then tighten the intake manifold bolts/nuts. Tighten all cylinder head bolts 90 degrees in sequence. Hope this helps.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]