|
Tractor Talk Discussion Board |
Re: No compression after changing head gasket
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jon Hagen on April 04, 2006 at 08:53:46 from (69.26.29.247):
In Reply to: Re: No compression after changing head gasket posted by Allis Trouble on April 04, 2006 at 08:32:20:
There is nothing to get out of line by turning the engine over with the head removed,and replacing the gasket is hard to get wrong to the point that there is no compression.
The only thing that comes to mind is IF the new head gasket is thinner than the old one,it would have closed up the valve gap and MAY be holding the valves off their seat. Check the valve adjustment to see if You have any"tight" valves.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
