Tractor Talk Discussion Board |
Re: Old Tractor Beat Me Up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MN Scott on April 02, 2006 at 20:38:56 from (206.9.216.29):
In Reply to: Re: Old Tractor Beat Me Up posted by Allan In NE on April 02, 2006 at 14:58:03:
Snow is gone around here but the mud is not. We have been getting an inch or so of rain every other day so the mud is bad, cattle are doing a good job of renovating the pastures. Had to park the 706 and get the Maxxum with mfd out just to get hay to the cattle. Getting a good start on calving the last couple days with 45 of 195 on the ground, calves don't seem to mind the mud haven't had much trouble yet. Starting to get the itch to go work some ground but with the weather forcasts it looks like its going to be a couple of weeks at least. I have 20 acres of corn stalks to spring plow for oats so I'll have to post some pics to of the 1066 and the 710 6-16 plow at work.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|