|
Tractor Talk Discussion Board |
Re: Barn door location?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by evielboweviel on March 31, 2006 at 18:12:27 from (65.24.181.184):
In Reply to: Re: Barn door location? posted by Nathan in Texas on March 31, 2006 at 17:57:36:
I like your idea of two doors on the left. also recomend framing for a door on the same side as your access door at the opposite end. Then you get into all the lighting, power, heat/ac, air pipeing issuses etc. I would install two inch foam under all the tin roof and sides. At least on the end where you want your little shop then you can build an interior wall so you can heat/ac that section and afford the utility bill. think about floor drains, one section totally flat for assembling projects and steel plates in the floor at various spots. insulate under the floor with foam if your area gets cold at night to stop it from sweating during the day. Good luck Ron
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|