|
Tractor Talk Discussion Board |
Re: Barn door location?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Stan(PA) on March 31, 2006 at 11:00:20 from (24.52.125.65):
In Reply to: Barn door location? posted by Nathan in Texas on March 31, 2006 at 08:19:48:
Mine is 30x40, and, yes, I wish it was bigger! Anyway, I"d go with the door in the center, so you have usable space against the walls, and the center is your "clear space" to drive out ect. If you add another door to the front, you lose a lot of space, because you have to keep the area in front of another door clear. I back the tractors against the side walls, and can pull any one out down the center of the building. I have tools ect. on one side of the door, and my sink and compressor on the other side of the door. The entire 2/3 to the rear is for parking my tractors. It works out very well with the center door (my door is 9 high by 10 wide). If you must have another door, put it in the center, rear of the building. That way, you still only need to keep that "center aisle" clear.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|