|
Tractor Talk Discussion Board |
Re: Levling site for barn
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Princeton Bill on March 28, 2006 at 14:37:49 from (152.163.100.74):
In Reply to: Levling site for barn posted by Nathan in Texas on March 28, 2006 at 13:52:59:
Nathan: First off I'm not a earthmover by trade, so I'm not pushing their "cause." If you are putting up a 30 x 40 metal building I'm pretty sure you want to have the best possible building when it is finished. A big part of that is the pad. If it is not done correctly you will not be happy with the end results. It appears that for now you want to leave the floor of the building dirt or covered with rock/stone of some sort. However, if sometime later you want to cement the floor it will be even more important to have a good pad. The first question I'd ask is how much time do you have to devote to the pad preparation and then I'd ask you how good you are with a loader? Unless you are pretty good with a loader, it will probably take longer than you anticipated and will be harder to get "right" than you anticpate. If you want to get some loader time, I'd recommend that you use the laoder to finish off the floor and the driveway after the building is constructed. Bottomline, I'd bite the bullet and pay the $1800 to get the pad professionally prepared.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|