|
Tractor Talk Discussion Board |
Re: Rock shafts- What the h#$$ are they?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Christos on March 27, 2006 at 21:46:19 from (130.108.236.146):
In Reply to: Rock shafts- What the h#$$ are they? posted by B. Abseck on March 27, 2006 at 21:16:39:
Ok rockshafts in a nutshell.... They are a rotating shaft to put it simply. In the case of the two banger John Deeres, they typically for the letter series and the subsequent children you could mount intergral equipment such as a cultivator, planter, etc. After 1953 and the resolution of the Harry Ferguson v Ford Motor Co. over the patents of the 3-Point hitch which uses the same principle of using a rockshaft to hydraulically lift an intergral implement to engage and disengage the soil (Draft Control) or to float on the surface (Response Control). So the three point hitch became the standard method of hitching and mounting intergral implements...any tractor built after 1955 will typically have one unless it was deleted at the factory. So a rockshaft is just part of the hydraulic system in a tractor as the rest of it makes up the rest of the story. There is an article on this site that deals with the three point hitch. If you get a two banger JD you can get a kit or go find an 801 hitch, which you can make into a 3-Point and put the arms onto the rockshaft - you'd have crude draft (as the pressure of lets say plowing would warp the steel top-link bracket) and have mainly response control the ability to float implements like a bush-hog on the ground. hopes this helps Christos
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|