|
Tractor Talk Discussion Board |
Re: Water wagon ideas?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on March 23, 2006 at 19:12:24 from (207.69.139.9):
In Reply to: Water wagon ideas? posted by Chances R on March 23, 2006 at 18:20:17:
If the tank has an outlet that is low on it all you need to do is plumb a pipe off that and have holes drilled in it. I would use at the largest 1/8 bit. You wouldn't even need to use the pump that way. Thats how a lot of local road builder have a truck set up to keep the dust down when there building roads. Seen a good many of them since I usto drive a dump truck and got a lot of jobs working on the roads in this area. Only problem I ever saw was the time it takes to get rolling after turning on the valve always leave a puddle.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|