|
Tractor Talk Discussion Board |
Re: Placement of Ballast Resistor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Thomas Donahy on January 15, 2006 at 11:40:26 from (64.149.37.47):
In Reply to: Re: Placement of Ballast Resistor posted by KEB on January 15, 2006 at 08:45:16:
Dear electrical wizards, Thank you for your responses, but I am still confused. The question is more than academic as I am presenting a workshop on point type ignition at the Gathering of the Green conference in March. Perhaps I can be more specific in my questions. 1. How does the secondary circuit return to the coil? Does it arc through condensor while the plug is firing? The voltage in the secondary is certainly dc as the spark line or I should say firing line is relatively flat on the scope and doesn't start to oscillate and become ac until the coil can no longer jump the plug gap. The circuit can't be completed through the points as they are open when the plug is firing. Does the secondary complete its path from the block, through the ground wire, through the battery,the key switch, and back to the junction inside the coil? Either way I don't see how the placement of an additional two ohms could possibly affect the secondary when you are dealing with up to 20,000 volts.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|