Re: jknapper's trailer crane

Posted by Keith-OR on January 10, 2006 at 22:01:12 from (207.200.116.199):

In Reply to: Re: jknapper's trailer crane posted by jknapper on January 10, 2006 at 09:00:01:

Here is a picture of my outrigger and dimentions.

main tube is 1 1/2 with 3/8 in holes drilled 1 apart. Slide is made from 2 inch tubing with 2 inch OD round tubing 5 inches long welded to the square tube. I welded 2 1/4 square tubing underside of trailer trailer frame.

With the round sliding inside square tubing, if load brings weight down to hard on outrigger foot all I do is either drive forward or backup off my outriggers.

I do not pin my outrigger so they will turn, and are easily removed.HTH

Keith & Shawn

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]