|
Tractor Talk Discussion Board |
Re: OT, septic tank
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on January 10, 2006 at 06:36:58 from (152.163.101.7):
In Reply to: OT, septic tank posted by Butcher on January 09, 2006 at 12:44:13:
Good advice, the lint in laundry waste water clogs the leach field prematurely, it is best to seperate waste water, when we built this place here, we installed a seperate tank/drywell to drain it off, it has a pipe that daylights on the side of a bank, keeps the area wet, might be a mosquito producer at worst, easily remedied with a stone pit or small drywell though. We used to do the site work for the local convienence stores around here that also dispense fuel, the tanks were filled right after they were set, to keep them from floating when a high water table existed. If you have access to a construction equipment rental house, you should look into the cost of a backhoe for a few days or a week, I can rent one for a week under $1000 per week delivered, with no insurance required around here. A competent operator could have that tank out and the hole prepared by noon, have a concrete tank delivered and set by a precast concrete supplier, then do the pipework, invert, outlet to the distribution box, (D-Box) set up to run your laterals, dig them so you can get the machine out and not run over the previously set ones, backfilling with a rubber tire machine you have to be careful. You'll need a 3-4 full size loads of clean #2 sieve size stone, few hundred feet of perforated pipe and a roll of red rosin paper to cover the stone on top of each lateral. Each lateral will take an equal portion of discharge from the tank, you can set the adjustment on the D-box for each, think we used to set the laterals at 1/8" per foot slope, been awhile I forget. I know with a helper, I could do the entire job in one day, ( we used to do 2 a day quite often, not bragging about it though, long days they were ) It may be wise to do a percolation test, have an approved design in hand, then order equipment and materials, but you may be able to save a significant amount by doing it yourself, than paying a contractors price. Unforseen things like ground water, rock, undesirable soil conditions cans low things down considerably, and make sure to call the " One Call" underground utility location service, have them mark off any utilities close by. Take a look on the internet, there are many typical designs to review, and if you or someone can operate a backhoe comfortably, their is good incentive to see what the job will cost on your own, it may prove out to be worth it. Contractors will usually be higher, overhead, profit and rightfully so, but when $$ are tight and you need something done, it's a good option in my opinion.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
A Belt Pulley? Really Doing Something? - by Chris Pratt. Belt Pulleys! Most of us conjure up a picture of a massive thresher with a wide belt lazily arching to a tractor 35 feet away throwing a cloud of dust, straw and grain, and while nostalgic, not too practical a method of using our tractors. While this may have been the bread and butter of the belt work in the past (since this is what made the money on many farms), the smaller tasks may have been and still can be its real claim to fame. The thresher would bring in the harvest (and income) once a y
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|