|
Tractor Talk Discussion Board |
Re: OT for sunday
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on January 08, 2006 at 14:17:47 from (64.228.11.41):
In Reply to: Re: OT for sunday posted by Coloken on January 08, 2006 at 06:55:52:
Ken: In 1971 I built a new dairy barn facility complete with milking parlor, office and wash room facilites. Every Sun morning my dad would come for a visit just as I finished milking. Usually we would sit out front facing the highway and enjoying the morning sun. We usually used 5 gallon pails for seats. He lived about 1/2 mile away and always walked over. Our road led to lakes, fishing, other sports, etc. Lot of traffic on Sun. morning. One such Sunday morning the bathroom fixtures had just been delivered and were setting on pad in front of building. Dad decided to use the thrown for his seat that morning. Finally after about a 1/2 hour of folks going by tooting their horns and waving, My wife emerged from the house advising that dad did look rather silly sitting on the thrown in front of the barn. Dad advised her he could flip the seat and take his pants down if folks were getting so much enjoyment from this. Marg. advised that wouldn't be necessary. I think we still have a photo of dad and I sitting out there in front of the barn. A couple of grand daughters thought it too good to miss. I think mom was sent out as a decoy just to keep us in position and talking.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|