|
Tractor Talk Discussion Board |
Re: Changing Tires
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BobReeves on January 03, 2006 at 17:05:37 from (70.184.21.197):
In Reply to: Changing Tires posted by Ranger John on January 03, 2006 at 12:29:20:
Late summer had a flat on the rear of my 3000. Called a local tire dealer and they gave me the number of a local guy that makes house calls. Was going to cost me $75.00 for him to come out and fix it. Sounded fair to me as I wouldn't have to mess with it. Guy shows up, breaks down the tire and we discover the flat was due to rust cutting holes on the inside of the tube. Needed a new tube and the rim cleaned up. I asked him if he could remove the tire from the rim and come back the next day to put it back together. In the mean time I would go get a new tube and clean up the rim. Went over the rim with a wire brush on an angle grinder and even used a grinding wheel to smooth a couple of spots. Sprayed the rim with a rust converter then painted with Rustolum. Next day he shows up and puts it all back together. Total charge was $100.00 for two trips but well worth it. The point of all this is you might think about getting someone to come out as I did and make sure your rims are ready for new tubes before putting them back together. Might spend a few extra bucks but at least you will know it was done to last a while.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|