|
Tractor Talk Discussion Board |
Re: Hydraulic Schematics/Ideas
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Midwest redneck on December 31, 2005 at 12:39:36 from (24.247.94.4):
In Reply to: Hydraulic Schematics/Ideas posted by Jeff C on December 31, 2005 at 12:18:00:
Be careful in doing this. You may need a flow divider valve for the two cylinders for the lifting of the bucket. You will need to size the lines for pressure and spike pressures. You will also need to look at systems on commercial tractors and see how they do it. Also (and this is important) be sure the tractor can handle the weight of the bucket and the material in the bucket. I have heard of tractors breaking in half due to having too much weight in the bucket and the tractor splits in two between the engine and transmission. I would look at Ford 660 tractors that have loaders and start from there.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
