Tractor Talk Discussion Board |
Re: Barn and Shop Lighting
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on December 30, 2005 at 09:48:31 from (66.244.90.98):
In Reply to: Re: Barn and Shop Lighting posted by Dan in Ohio on December 29, 2005 at 13:19:10:
Dan, everything might look sort of yellow if used indoors, not so bad for warehouse storage, although they have improved with new lamp coatings. The Metal Halide HID with coated lamps dont look too bad if you choose to go with HID. The High Pressure Sodium are more for parking lots etc. In small shops a lot of guys mix some Metal Halide HID over the storage areas but strip fluorescents (with good reflectors) or incandescents over the work benches where HID could pose some glare n reflection problems. Many many years ago I attended a week long Lighting Seminar at GE"s NELA Park facility but I done forgot most of that by now. John T
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|