|
Tractor Talk Discussion Board |
Re: Water Well Problems 2
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gary Schafer on December 25, 2005 at 09:01:05 from (71.57.149.211):
In Reply to: Water Well Problems 2 posted by john in la on December 25, 2005 at 06:56:11:
Hi John, You didn't say what type well you have. Is it a sand point driven down? If so then you can't use a foot valve on it. The foot valve would break as you tried to drive the point. The check valve at the top should work fine if you have no air leaks in the well pipe above the water table. Your intake line from the well to the pump should not make a loop above the pump and down again. Air can get trapped in the loop. The best way is to come off the well with a 90 and go straight over to the pump. If your check valve is leaking then the tank will drain down over a period of time but the pump will still maintain its prime and start ok as long as the tank doesn't go empty on you. Once all the water leaks down then it will also loose its prime. If the tank is not leaking down but the pump is loosing its prime then you have a leak between the check valve and the well. Did you change the point or well pipe recently? Another problem may be the amount of lift you have from the pump to the house. You mentioned 220 feet. Is that horizontal or is part of that vertical lift? If you have a large vertical lift then the water in that pipe will provide back pressure and may be enough to not allow the pump outlet pressure to drop low enough to turn on. If so then you would need to change the pressure switch setting. Prime the pump, get it working and watch the gauge to see where the pump starts and stops as water is run. Then turn off the power to the pump and open a faucet at the house and watch the pressure gauge to see how low it goes when there is no more water coming at the house faucet. That will tell you how much back pressure you have in the water line from vertical lift. Regards Gary
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Implements and Their Use - by Curtis Von Fange. Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he reached his early sixties
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|