Re: getting a ball hitch to fit on a three point t

Posted by Jim.UT on December 22, 2005 at 12:15:24 from (64.122.18.247):

In Reply to: getting a ball hitch to fit on a three point tract posted by Jim St. Aubin on December 22, 2005 at 07:54:44:

Here's a diagram (robbed from SpeeCo's website) of a drawbar lock. The oblong opening is where the end of your 11 hole drawbar goes. The other part of the lock clamps to your lift arm. The keeps the drawbar from rotating.

Then you just bolt the appropriate size ball to one of the holes in the drawbar and you're ready to go.

You can go the other route also as pictured by Tim, but then you have to crank the trailer up and down to hook it up. With the 11 hole drawbar you can just back up to the trailer with the 3 point lift down, then when you're under the hitch of the trailer, lift up on the touch control to hook up the trailer.

You'll probably have to go to TSC to get the lock. I think SpeeCo only sells wholesale to dealers, but I could be wrong.

• Drawbar lock on SpeeCo website

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]