|
Tractor Talk Discussion Board |
Re: Help!Cracked block
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Sloroll on December 19, 2005 at 15:41:01 from (69.66.221.164):
In Reply to: Help!Cracked block posted by dantanner on December 19, 2005 at 15:09:50:
I am sure you will get much better advice but if the crack isn't wide but is a hair line fissure, you can minutely grind into the cast just a bit along the break. Stop drill each end and tap for a small bolt. Drill and tap for a small bolt every 2 inches or so. Grind off the bolt heads then fill the crack gind with JB weld. This is assuming a water jacket freeze type of crack and not a fatigue break requireing a lot of strength. If left alone this repair will last and be virtually invisible. Again, it has to be in a non stressed area.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
A Towny Goes Plowing - by Anthony West (UK). I live in an area renowned for its rural beauty. Small fields with hedgerows and trees are common place, as are small hamlets with village greens and the odd duck pond complete with swans. The center of any village once the shop is closed is the old tavern. Rustic places with cheerful names like "The Griffin" "Red Lion" or "The Plough and Harrow" are found dotted around the country lanes all over the place. The warm glow of yellowish light can be seen for quite some distance at dusk, and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
