|
Tractor Talk Discussion Board |
Norman with 4010 PTO promlem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MN Bob on December 16, 2005 at 13:24:16 from (24.179.179.185):
Norman; Sorry to take so long. Was out at the farm this morning, good new I have the operators manual. Bad news I cannot find the service/parts manuals so must have loaned them out or misplaced them. below the tractor you can see the front PTO. There is a plate right above it. That is the PTO clutch inspection plate and there are 2 lube zerks in there. I believe with that off you may be able to see back or use a mirror. one zerk is seen with PTO in nuetral, The other when the shaft is pushed forward. If The assembly does not move you will have something disconnected but if it moves the problem is elsewhere. The tractor should NOT be running when you move the lever. If you have a JD dealer nearby ask to look at the service and parts manuals. Local dealers here are helpful, hope yours is to. Email me at home again, I lost your address. [email protected] Bob
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
