|
Tractor Talk Discussion Board |
Re: GM atlernator for tractor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on December 12, 2005 at 10:05:50 from (66.244.90.98):
In Reply to: GM atlernator for tractor posted by INcase on December 12, 2005 at 08:43:19:
IN, In addition to the good advice below, I additionally use and recommend a 10 ohm current limiting protection safety resistor in that excitation voltage circuit that wires from a switched battery voltage source (such as the Ignition switches IGN output terminal that wires to the ignition coil etc) to the alternators lil No. 1 side excitation terminal ESPECIALLY if you only use a diode and not an idiot charge indicator light. (Depending upon an idiot light bulbs resistance if you used one, you may not even need any other resistor or diode???) If you dont use an idiot light but the 10 ohm resistor I recommend in the excitaiton circuit and should the engine still run on even after the ignition is switched off, then you would need to add the diode (one way current flow check valve). Often the use of the resistor or idiot light may make the diode not even needed. (it will stop any run on problem) Ive seen them wired direct with no resistors and without any idiot lights that worked just fine while others had to have the diode to prevent run on. Im a strong believer in an ounce of protection is worth more then a pound of cure and as an added safety feature I use the 10 ohm current limiting safety resistor myself, but its your tractor and your choice. John T PS this is for a GM 10SI 3 wire alternator, dotn forget it requires NEGATIVE GROUND !!!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|