Re: HS huber piston needed

Posted by RAB on December 11, 2005 at 14:41:05 from (195.93.21.101):

In Reply to: HS huber piston needed posted by mike 28 OCH on December 11, 2005 at 09:59:05:

Hi,
Haven"t a clue as to actual engine but here are a few questions - the answers to these might help you get a better response.
Cast iron or aluminium?
Small end diameter?
Piston height over gudgeon pin?
Flat top, dome or concave?
Anything else that might be special?
Could engine be bored for a larger standard size?

An alternative might be easily available.
I am surprised at the reply from Jerk. "I need", to me, means you would be prepared to pay for one and wouldn"t expect it to be free?
Regards, RAB

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]