Tractor Talk Discussion Board |
Re: Replacing Mechanical Fuel Pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Keith-OR on December 11, 2005 at 12:02:35 from (207.200.116.199):
In Reply to: Re: Replacing Mechanical Fuel Pump posted by old on December 11, 2005 at 11:17:20:
Old, it makes no difference on the pump, Just depends what part of the country you are in, cause they don't even ask that question here. I just put a new pump on my 1 ton Ford, it has the same part # as my 3/4 Ford with same motor. And it did not even make a difference between 4bbl and 2 bbl carb.... Just my experience Keith
Replies:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|