Tractor Talk Discussion Board |
Re: Guess I'm going to have to scare the snow away
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mn Dave on December 06, 2005 at 05:35:03 from (72.2.198.2):
In Reply to: Guess I'm going to have to scare the snow away. posted by old on December 05, 2005 at 20:56:36:
Yeap, but you got to be ready for the "BIG ONE". So far this year we got about 6 in. of snow on the ground and this morning it was -13 and thank God no wind. I raise beef cattle and hogs, and for the last 25 years have this little hobby of blading and plowing snow for the township I live in. The photo is of my '72 Oshkosh plow truck that I use. I use it 99% of the time for plowing, beats a motor grader all to hollow. GVW on the truck is 42,000 lbs. It also has a 12 foot wing hanging out of the other side. Have big V-plow for it but it has to be pretty deep to put that on, at least it is quick tach if I need to put it on.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|