|
Tractor Talk Discussion Board |
Re: Ford 960 and snow
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bcPA on December 04, 2005 at 21:23:50 from (172.129.60.131):
In Reply to: Ford 960 and snow posted by Nebraska Cowman on December 04, 2005 at 14:27:45:
bigger tires will give you less pounds per square inch on tire tread. I think you want more in this department. Like having a ladys spike high heel jabbed into your foot. If possible I would turn the blade around and push with the tractor in reverse. Skids runners may be what you need also. But if your whole area to plow is paved then a cutting edge in direct contact with the pavement really does a nice job. If you have frozen ground then a rock sticking up a inch or so frozen solid in the ground will bend or break something or send you flying , off the tractor maybee, when a cutting edge grabs the sticking up object. With the blade turned around you dont pull snow up to your rear wheels where it gets in your way. Also when you stop and raise the blade to go forefard you will then be turning your wheels in the right direction for good traction and the weight of the blade will also help with traction. So you wont get stuck as often. Maybee you know all this but some newbee may benefit. Also I have wheel weights on my 8 n and they really help. I have a 7 ft blade and wish it were wider with a sliding offset feature.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|