|
Tractor Talk Discussion Board |
Re: Flywheel inspection port.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jerry/MT on December 01, 2005 at 17:22:02 from (209.247.222.47):
In Reply to: Re: Flywheel inspection port. posted by RAB on December 01, 2005 at 11:52:13:
Buy it originally had the timing mark hole in the casting! They probablly took it out to save money. They didn't have to mark the flywheel, didn't have to offset the hole in the flywheel and they didn't have to mold and then machine the hole in the block casting. They just had to cast a mark on the timing cover mark the crank pulley and index it to the crankshaft.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
