|
Tractor Talk Discussion Board |
O-T Black powder guns
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on November 27, 2005 at 12:00:50 from (207.69.136.204):
Any body else mess with the muzzle loaders and or hunt with them?? I just pull my 50 cal off the rack today to get it ready and found it all rusty, I always clean it before putting it back up but every time it come back dow its the same old thing rust every where. Is there any tricks to keep them from rusting up so bad. This time the nipple for the cap was rusted close and I almost didn't get it opened back up. Weather man is calling for a light snow so if it does I'm going out hunting with it but only if it snows.
Thanks
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
