Re: modifying rops

Posted by paul on November 22, 2005 at 09:35:11 from (66.44.137.218):

In Reply to: modifying rops posted by jaybird-oh on November 21, 2005 at 17:05:03:

The problem is how do you test out if your
fabrication skills are good enough? :)

There get to be some very thorny issues on
liability & so on if you sell the tractor, or
someone else is operating it & gets hurt. Only
a 1 in several million chance, but the point is
there.

The latch will need to handle all the forces of a
roll over in all directions, and the current roll
bar will need to be able to handle being cut &
having that soft point in it.

Just idle thoughts, likely you can do it if you
plan out the different stresses & all. A lawyer
would tell you no way....... ;)

--->Paul

Follow Ups:

• Re: modifying rops Martin Cooper 00:30:46 04/06/06 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]