|
Tractor Talk Discussion Board |
Re: OT building cabin/shed
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill in NorthCentral PA on November 14, 2005 at 15:35:28 from (24.229.41.157):
In Reply to: OT building cabin/shed posted by Bryan In Iowa on November 14, 2005 at 11:08:53:
I built a 14x28 for a cabin a couple of years ago. Not that this is "gospel", but it is what I did. I drilled holes for 6x6 treated posts, and fastened treated 2x10 headers to them. On top of this, I framed the floor and sheathed with plywood. For the walls above this, I conventionally framed them, etc. Mine has an 8" porch on one end, with 12x12 loft over the porch and into the cabin itself. I closed the walls in with hemlock board & batten and shingle roof. I framed the open section of roof with a "truss" design and the loft with a cathedral ceiling. First floor walls are 7", with a total wall height of 14" (which is about 6" upstairs after the loft floor framing. I would expect that this may fly for your use with some ingenious ramp system (or taking advantage of the grade of the site, etc. Sorry so long. Bill
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|