|
Tractor Talk Discussion Board |
Re: boat work
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kevin (FL) on October 27, 2005 at 19:08:26 from (12.77.199.9):
In Reply to: boat work posted by chris sweetland on October 27, 2005 at 17:51:37:
Chris, If you're talking about a workboat, sand with 80-120 grit paper and apply 2 coats of epoxy paint made for fiberglass surfaces. The sanding will remove the glossy finish of the gelcoat but will provide a good anchor for the epoxy finish. This will not be a glossy finish but a durable one. Epoxy is not easy to spray on though unless you do it alot and have good equipment. If you want a yacht-like glossy finish, then you should use a special primer that breaks down the gelcoat finish and adheres better. Some folks used a diluted muratic acid solution to clean the gel coat before appying primer. (There are several different surface prep requirements that depend on what the final surface needs to look like.) Then you can apply either marine enamel or polyurethane depending on how much money and what equipment you have. There are several manufacturers of marine paint for fiberglass boats and if you can locate a paint rep in your area, he can provide tons of advice for your specific application. Most or all of the marine paint manufacturers will provide plenty of tech info when contacted. Some of the major brands: Ameron, International, Sherwin Williams, Devoe, Hempel (Locally we have a good company called BLP--paint is made near Mobile, AL) A good website for a marine distributor that also sells paint and has tons of tech info too:
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|