|
Tractor Talk Discussion Board |
Re: Kubota vs John Deere
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry/MT on October 24, 2005 at 10:30:06 from (206.183.121.163):
In Reply to: Kubota vs John Deere posted by Beamer on October 23, 2005 at 22:32:04:
I remember some of Kubota's early attemps at entering the US market with compact tractors. Final drive gear cases made out of stampings! But they, like all the Far Eastern manufacturers have a long term view of the market and today their equipment appears to be competitive with anything out there. And it will only get better, so look out Deere, etc!!! I don't have any axe to grind over any of your choices and that's mainly because I haven't looked at buying anything reasonably new. The newer tractors are a lot harder to work on because of the electronics in them, from the fuel controls to the hitch controls, etc. They are also said to be more reliable and require less maintenaance, just like our modern cars. Your old 3600 can be worked on by an average mechanic with the tools that are in the average shop without a suite of expensive, electronic, diagnosic analyzers. Don't know your financial situation but you ought to consider life cycle costs as well as initial cost and certainly the cost of ownership includes maintenance. And remember that all these manufacturer make a great deal of money selling parts. It's a big profit center for them. (I'm not saying that's bad, that just the way it is.) I guess I'd look into what it would cost to "zero time " that old 3600,and include that in the data before I'd make a decision. But then I am partial to these old machines. Good luck whatever choice you make!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|