|
Tractor Talk Discussion Board |
2020
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rb-1 on October 19, 2005 at 04:20:16 from (24.176.111.5):
Can anyone shed some light on how complex my situation may be?
I have a JD 2020 with, what I believe to be a cracked head or gasket.
There is, after running a while, a fair amount of steam exiting the crank case vent tube.
The oil is a bit milky also.
Ive been told the crack can be repaired as good as new, I dont see how, however, Im no mechanic, so ,Im interested in any and all opinions out there.
I need to have this running asap.
Also, what other components can be replaced during this stage of tear down? rings? bearings ect?
Do you think theres any damage to the rod bearings ect. from the A-freeze & water which entered the crank case?
Thank you for any guidance you can give.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
