|
Tractor Talk Discussion Board |
Re: Will straight pipe hurt motors??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark - IN. on October 14, 2005 at 20:04:51 from (152.163.101.7):
In Reply to: Re: Will straight pipe hurt motors?? posted by Jerry/MT on October 14, 2005 at 14:07:12:
You're correct on richening to a point. Richer typically will run cooler, however too much richening will burn unburnt gasses into the exhaust runners, hence the gold or bluing of the pipe. That can be bad too, if over done. When running an air cooled, instead of idling non-stop, is better to pop the throttle occasionally because that instant short reflux of cool gas into the cylinder actually provides a momentary cooling. When I pop the hog at an intersection on a hot day, not trying to show off or drive the folks ears nuts, just trying to keep a 97" shovel from seizing and having to put another $5K into the motor. Been there, done that. Besides, S&S backs me on that one. I hear guys talking about the racers do this, and the racers do that, but those are very expensive throw away engines from an aspect of at least tearing them down and rebuilding per run (drags) or race (oval). Not too many folks gonna do that to the old A, Jubilee, etc. I think some are confusing what they think optimum is, with reliability. Mark
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|