Re: metal siding

Posted by Bill in NorthCentral PA on October 12, 2005 at 09:02:06 from (209.50.143.180):

In Reply to: metal siding posted by memmo on October 12, 2005 at 07:14:43:

I always (roof or sides) screw in the flats. I clamp the whoile stack of applicable sheets, lay out my locations, and drill a small hole where the screw goes. This helps keep the final product looking professional. I install in the center of the flats (9" on center ribs have four sections each, often with minor ribs in each section). I center the screw in the flat next to the rib. I screw all "minor" flats at top, bottom, and any overlaps.

Good luck,

Bill

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]