|
Tractor Talk Discussion Board |
Re: Advice on digging up rocks
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MPK on October 03, 2005 at 13:25:19 from (66.60.222.212):
In Reply to: Re: Advice on digging up rocks posted by wayne2 on October 02, 2005 at 20:26:50:
I made a rock digger a long time ago and used it as long as i needed to. It fit on the 3 point hitch on the tractor. It was made from 2 plow beams side by side spaced about a foot apart. Then about half way back I had a set of 3 teeth on a shaft that was operated by a hydraulic cylinder. This was used to pick up the rock after it was dug out. I would carry the rock off the field with it. It worked very well. My son in law still uses it. He is on my farm.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
