Tractor Talk Discussion Board |
Re: OT: Tracing an electrical line
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John T on October 03, 2005 at 07:03:27 from (66.244.90.98):
In Reply to: OT: Tracing an electrical line posted by wirehair on October 03, 2005 at 04:54:19:
I think Ive seen a non contact electrical test device at some home or elecrical supply house a while back that lit up when in the proximity of AC voltage, it must detect the electromagnetic field. So long as the feeder were hot out of the panel such a device might locate it if close enough to the walls or ceiling etc. If you know what circuit that receptacle is on fed from you breaker box you could disconnect it there and ohm out the conductors to see if any wires are showing high (or low even) resistance continuity to other conductors. Even a high resistance short should cause the GFCI to trip out as I think they drop out at something like only 5 milliamps of current imbalance between the hot and neutral. However, the GFCI should also drop out even if there were no hot to neutral shorts discussed above but a short to the trailers metal frame as the result would still be an imbalance in the hot and neutral current flows. I would ohm out the conductors as thats cheap n easy (but even if they pass there may still be a short elsewhere) and then purchase one of those AC Voltage detectors if you need to locate where the wire is. Have you checked the GFCI elsewhere to be sure its okay and dont trip out any old place????????? John T, retired electrical engineer
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|