Re: Concrete wheel weight idea.

Posted by MN Bob on September 27, 2005 at 06:36:03 from (24.179.182.231):

In Reply to: Concrete wheel weight idea. posted by 300Randy on September 26, 2005 at 13:54:52:

Lots of good answers, I think you are worried about releasing the form after it is cured? If you use wood you dont need to worry. If you weld up a metal form that can be clamped togather, front and sides one section, rear left in place with small rods welded on to stick into cement/concrete for re-envorcment you should not have problem either. If you can find a strong platic barrel or bucket the right size around, it might work great. Be sure to vibrate or use a hammer to pound on the form to prevent voids as you fill. calcium chloride as suggested works great, but rusting wheels are the down side.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]