Tractor Talk Discussion Board |
Re: Cast iron...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Duner Wi on September 22, 2005 at 18:36:58 from (63.50.8.139):
In Reply to: Cast iron... posted by Stan(PA) on September 22, 2005 at 08:43:08:
I have been using a self etching primer from BASF # Zip 834 for many years and like it lots. I keep some in one gun and when I get something clean I spray a couple of thin coats. As long as I keep it indoors and dry I can let it set for years with out rust coming back , When time to paint I give it another coat and then paint shortly after. Epoxy primer might do the same for you but I don"t like mixing small quanities of primer with a limited shelf life after mixing. I have put epoxy (Nason) over Zip 834 but it was only 3-4 years ago so don"t really know how it is for the long term. I would expect it to last tho. I would not put rust converter on anything I had a lot of labor in. I have used it when in a bind and it did work for for a few years. Good Luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|