|
Tractor Talk Discussion Board |
Re: Chained ???????
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john in la on September 20, 2005 at 20:23:35 from (65.6.111.233):
In Reply to: Chained ??????? posted by Ohio Puller on September 20, 2005 at 19:02:32:
With 3/8 grade 70 you are well covered. This chain is rated at 6,600 lbs so you could use it on a 13,200 lb tractor. Many people give that 4 point rule as true for any size tractor but federal law says 4 chains for over 10,000 lbs. Your state rules may differ but it is hard to say. Straps can be used on tractors BUT you MUST use edge gaurds and this is the point that most forget about. Flip over binders while dangerous are legal. One point to remember is your chains must be marked grade 70. If the tag falls off or the paint wears off they will be considered grade 30 in which case they are only good for 2650 lbs or a 5300 lb tractor. For your 5500 lb tractor you can use.......... 7/16 grade 30......3700 lbs 5/16 grade 43......3900 lbs or 1/4 grade 70.......3150 lbs
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|