Tractor Talk Discussion Board |
Re: bent spindle?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Dan on June 02, 1999 at 11:05:58 from (205.183.237.69):
In Reply to: bent spindle? posted by scott on June 01, 1999 at 16:56:07:
Your comment about the spacing between the tire and the spindle sure sounds like something is bent. One other area to check would be the tie rods. Make sure that it is centered. There should be an equal amount of threads showing on the ball joint ends on each side. Also check the alignment. Measure carefully the distance between the front tires, both on the front side and the back side of the tires, level with the spindle. The alignment should be adjusted for a slight toe-in, where the distance between the fronts is about 3/8" closer than when measured in the back.
Follow Ups:
Post a Followup
|