|
Tractor Talk Discussion Board |
Re: Need job advice
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mike brown on September 13, 2005 at 06:11:01 from (132.236.155.108):
In Reply to: Need job advice posted by Mike in Ind on September 12, 2005 at 13:53:00:
Mike; You sound like a young man so I'm going to give you the same advice I scoffed at thirty-five years ago to my regret. Get more education. Get more education. Get more education. As you get older you can't work harder only smarter. I served two years in the Army and as much as I disliked it at the time I have to admit that it taught me some life lessons that have served me well such as mental toughness and perserverance. If I had it to do over I would have joined the Air Force and let them theach me to work on high tech cool stuff like jet engines or airframes since I too am mechanicaly inclined. There are a lot of training opportunities in the service. The news makes it sound like everybody is getting shot at but it isn't the case.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|