Tractor Talk Discussion Board |
Re: OT ---making assumptions, not a good thing....
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MarkB_MI on September 12, 2005 at 19:48:07 from (64.31.10.224):
In Reply to: OT ---making assumptions, not a good thing..... posted by NC Wayne on September 11, 2005 at 19:40:53:
Spoken like a true North Carolinian. I lived in your fine state for seven and a half years, and seldom met a native who would actually come out and say that smoking is bad for you. Your argument is like saying "diabetes in inherited, so if I'm going to get it there's nothing I can do. I might as well stick with my RC Colas and Moon Pies, because it isn't going to make any difference anyway."
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|