Re: Impact of drift pin - JMS/MN and others

Posted by RAB on September 12, 2005 at 11:45:59 from (195.93.21.100):

In Reply to: Impact of drift pin - JMS/MN and others posted by Hendrik on September 12, 2005 at 08:09:44:

If one of those balls were made in a soft material, that one would deform first. I always(?HaHa!) use a soft faced mallet or a brass drift. It is just like crank shaft/bearing wear - it is always the softer crankshaft metal that slowly wears away while that little old white metal bearing remains good until you knock it out or destroy it with lack of lube.
Regards, RAB

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]