|
Tractor Talk Discussion Board |
Re: OT: need advice from machinists
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Davis In SC on September 10, 2005 at 18:15:14 from (205.188.117.6):
In Reply to: Re: OT: need advice from machinists posted by Midwest redneck on September 10, 2005 at 18:01:17:
The true cost of cheap tooling is hidden... They do not count the trips over to China, Air shipping of samples, Phone calls, etc... In the long run , they pay more for it, & often it is unusable... The last 2 ChiCom molds that came through our shop were a joke... I recommended that they be scrapped, no way to make Chicken Salad out of Chicken S%^t... I did not even want to get involved in the problems that they could cause.. One was for a small part that went in a Luxury Automobile, proction line had to start in a week... I hope they got parts out of it, LOL I better stop before I start ranting..
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
