|
Tractor Talk Discussion Board |
Re: how to drive a tractor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RodinNS on September 08, 2005 at 18:01:36 from (142.177.80.78):
In Reply to: how to drive a tractor posted by Markay on September 08, 2005 at 04:27:54:
It's your tractor.... you can stipulate how it's to be driven, and that ought to be respected. That said, I use the pedal most of the time. I use the throttle lever very little, with the exception of maintaining a set PTO speed. In my book, that's about all it should be used for. It's a lot easier and more efficient to use the accelerator pedal for most other work. What I would recommend is that anybody that insists on shifting a transmission at a set throttle speed when they don't need to maintain a set RPM needs a good swift kick in the pants. That's why the pedal was put there, yet some persist in driving a modern synchro tranny like it was a 9N, and putting needless strain on clutches and synchronizers, and getting nothing done to show for it. I've seen enough of it. That's my little rant for the night.... As far as revving the engine goes, it's not going to do any more than burn fuel with nothing to show for it. That can be just as easily done with the hand lever as the pedal too. Technically speaking, an engine should never really be operated at a constant load or speed. When I was in trade school, that was one subject often talked about. The reason was that constant load and speed could lead to cylinder glazing, and require a premature rebuild. You might also notice in the operators manual, that they do not recommend that the tractor be operated at light loads for long periods of time, particulairly in the break in period. They do suggest operating at a variety of speeds and loads. That's a good enough book for me.... Rod
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|