|
Tractor Talk Discussion Board |
not 100 percent
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Coloken on September 02, 2005 at 12:50:05 from (216.17.251.130):
In Reply to: OT.. gas price's posted by TIm Shultz on September 02, 2005 at 10:48:12:
I did a lot of research on this the last time around, about doing your own on the farm. Forget it for a big reason. You can get it up to good drinking proof and higher very easy. But: to get it that last bit without water so as to burn it for fuel is very hard. You need some thing like 98-99 percent or 180 proof. What I am trying to say is that last percent or two of water is hard and dangerous to remove. Mother Earth News had the simplest still. Like a 4 to 6 inch copper pipe 12 to 16 foot tall. Filled with old bolts and nuts for fuel grade or marbles for drinking stuff. Kennyp
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|